Misurazione e protezione
Trasduttore di misura e dispositivo di protezione per sistemi di alimentazione mono e trifase.
-
- collegare un PLC tramite bus CAN
- utilizzare i relè per inviare comandi e per controllare un interruttore
Misurazione
easyprotec 1410 | MFR300 | |
---|---|---|
Funzioni | ||
3 ingressi di tensione RMS vero | ||
3 ingressi di corrente RMS vero | ||
Precisione di misura di classe 0,5 | ||
Setpoint di scatto/controllo configurabili | ||
Temporizzatori di ritardo configurabili per allarmi individuali (da 0,02 a 300,00 s) | ||
4 relè configurabili (in scambio) | 2 | 4 |
1 Relè “Pronto per il funzionamento”. | ||
Logica a relè commutabile | ||
Contatori 2 kWh (max. 1012 kWh) | ||
2 contatori kvarh (max. 1012 kvarh) | ||
Comunicazione CANopen/Modbus | ||
Configurabile tramite CAN bus / RS-485 / Porta di servizio (USB/RS-232) | ||
Configurabile tramite porta di servizio (USB / RS-232) | ||
Protezione | ||
Sovra/sottotensione (59/27) | ||
Sovra/sottofrequenza (81O/U) | ||
Asimmetria di tensione (47) | ||
Sovraccarico (32) | ||
Carico positivo/negativo (32R/F) | ||
Carico sbilanciato (46) | ||
Sfasamento (78) | ||
Sovracorrente (50/51) | ||
df/dt (ROCOF) | ||
Guasto a terra | ||
Monitoraggio QV | ||
Aumento di tensione | ||
Monitoraggio della sottotensione in funzione del tempo liberamente configurabile per: FRT (Fault Ride Through) |
MFR-300 Multifunction Relay / Measuring Transducer with CANopen / Modbus Communication
The MFR 300 is a measuring transducer for monitoring single- and three-phase power systems. The MFR 300 has both voltage and current inputs for measuring an electrical power source. A digital processor makes it possible to accurately to measure true RMS values, regardless of harmonics, transients or disturbing pulses. The primary measured and calculated values are transmitted via CANopen / Modbus protocol to a supervisory control system.
The MFR 300 performs monitoring functions for mains decoupling, including four freely configurable time-dependent undervoltage monitoring functions for FRT (fault ride-through).
The primary measured values of voltage and current are used to calculate the real, reactive, and apparent power and the power factor (cosphi) values.
Accessori
Kit di strumenti
configurazione tramite il Software Toolkit standard di Woodward.
Interfaccia di configurazione USB
Interfaccia di configurazione della porta USB. Il lato PC/laptop è separato dal lato unità Woodward tramite isolamento galvanico.
numero di parte: 5417-1251