Medição e proteção
Transdutor de medição e dispositivo de proteção para sistemas de energia monofásicos e trifásicos.
-
- conectar um PLC via CAN bus
- use relés para enviar comandos e controlar um disjuntor
Medição
easYprotec 1410 | MFR300 | |
---|---|---|
Funções | ||
3 entradas de tensão True RMS | ||
3 entradas de corrente RMS verdadeiras | ||
Precisão de medição classe 0,5 | ||
Pontos de ajuste de desarme/controle configuráveis | ||
Temporizadores de atraso configuráveis para alarmes individuais (0,02 a 300,00 s) | ||
4 relés configuráveis (comutação) | 2 | 4 |
1 relé “Pronto para operação” | ||
Lógica de relé comutável | ||
2 contadores de kWh (máx. 1012 kWh) | ||
2 contadores de kvarh (máx. 1012 kvarh) | ||
Comunicação CANopen/Modbus | ||
Configurável via CAN bus / RS-485 / Porta de serviço (USB/RS-232) | ||
Configurável via porta de serviço (USB / RS-232) | ||
Proteção | ||
Sobre/subtensão (59/27) | ||
Sobre/subfrequência (81O/U) | ||
Assimetria de tensão (47) | ||
Sobrecarga (32) | ||
Carga positiva/negativa (32R/F) | ||
Carga desequilibrada (46) | ||
Mudança de fase (78) | ||
Sobrecorrente (50/51) | ||
df/dt (ROCOF) | ||
Falha de aterramento | ||
Monitoramento de QV | ||
Aumento de tensão | ||
Monitoramento de subtensão dependente do tempo livremente configurável para: FRT (passagem de falhas) |
MFR-300 Multifunction Relay / Measuring Transducer with CANopen / Modbus Communication
The MFR 300 is a measuring transducer for monitoring single- and three-phase power systems. The MFR 300 has both voltage and current inputs for measuring an electrical power source. A digital processor makes it possible to accurately to measure true RMS values, regardless of harmonics, transients or disturbing pulses. The primary measured and calculated values are transmitted via CANopen / Modbus protocol to a supervisory control system.
The MFR 300 performs monitoring functions for mains decoupling, including four freely configurable time-dependent undervoltage monitoring functions for FRT (fault ride-through).
The primary measured values of voltage and current are used to calculate the real, reactive, and apparent power and the power factor (cosphi) values.
Acessórios
Conjunto de ferramentas
configuration via Woodward’s standard Software Toolkit.
Interface de configuração USB
Interface de configuração da porta USB. O lado do PC/laptop é separado do lado da unidade Woodward por meio de isolamento galvânico.
número da peça: 5417-1251